Koine 35 Evo
Single-phase continuous cycle spraying and mixing pump. Hopper capacity: 140 l.
Hopper capacity: 140 l
Material flow: 7-17 l/min
Max installed power: 3.85 kW
Weight: 255 kg
Suitable for pumping or spraying all dry premixed materials. Feeding from bags or from silo. 4 pumping speeds available. Diaphragm compressor IM 250 – 0.75 kW.
Suitable for pumping or spraying all dry premixed materials:
- Cement / lime / gypsum plaster based
- Structural reinforcement mortars
- Structural plasters
- Restorative plasters
- Stucco
- Binders / mortars for injections
- Grout / Core-Fill Grout
- Glues for thermal insulation coatings
- Thermal insulating screeds based on cork or polystyrene
- Insulating plasters based on polystyrene or cork
- Fireproofing mortar
- Self-levelling cement-based screeds
- Self-levelling anhydride-based screeds
- Mortars for fire protection
The high efficiency of the electrical components, including the exclusive IMER A1 inverter, allows the Koine 35 EVO to work even with the minimum electrical power available in most homes (3 kW). Select the most suitable among the four pumping speeds available, which can be shown on the display.
The bagged material, or material coming from the silo, is poured into the hopper, where a feeding wheel fills the mixing chamber continuously and constantly.
The water necessary to obtain the mixture is injected into the mixing chamber by a stainless steel pump. The water flow is kept constant through a particular stabilization system and controlled by a valve that starts or stops the flow if necessary.
The amount of water in the mixture can be viewed in the flow meter and can be adjusted according to the needs through a micrometric valve. The material is mixed with water and immediately sucked by the eccentric screw pump and pushed into the pipe until it reaches the end of the spray gun. From here, with the help of the air supplied by the standard integrated compressor, it is sprayed on the application area, from a distance of about 20 cm. The material flow can be started or stopped directly from the spray gun by opening or closing the air valve.
Washing is simple, very fast and without water and material spilling in the work area. The only area that needs to be cleaned is the one where the mixture takes place, while the unused dry material can remain in the hopper and be removed if necessary, by opening the appropriate discharge plug at the bottom of the hopper.
Koine 35 EVO is equipped with safety protections that immediately stop the electric motors if the mixing chamber is opened, signaling the event with an indicator light and an indication on the display. The machine is also equipped with status diagnostics, which ensures electrical protection in any case of system overload or use anomaly.